Vtp domain currently not in updating state

Posted by / 12-Aug-2017 00:25

Vtp domain currently not in updating state

This is because when a switch receives an untagged frame, it will assign that frame to the native VLAN. - D is not correct (Reference: The native VLAN that is configured on each end of an 802.1Q trunk must be the same.1DSW1#show vtp status VTP Version Configuration Revision Maximum VLANs supported locally Number of existing VLANs VTP Operating Mode VTP Domain Name VTP Pruning Mode VTP V2 Mode VTP Traps Generation MD5 digest 0x E9 0x3D 0x3C 1005 6 Server building1 Disabled Disabled Disabled 0x0B 0x ED 0x6C 0x E2 0x16 Configuration last modified by 172.16.1.111 at 3-1-93 Building Cisco Multilayer Switched Networks (BCMSN) v3.0 © 2006 Cisco Systems, Inc.Local updater ID is 172.16.1.111 on interface Vl1 (lowest numbered VLAN interface found) The new switch, 1ASW3, has not yet been connected to the network.Server Mode – In VTP server mode you can create, modify and delete vlans.VLAN information is synchronized with other VTP servers and clients on the VTP domain.

The correct encapsulation type has not been configured. The no shutdown command has not been entered for the port. D E Explanation VLAN Trunking Protocol (VTP) is used to ensure that all switches in a given group, or VTP domain, have the same information about the VLANs that are present in that domain.

2-100 Building Cisco Multilayer Switched Networks (BCMSN) v3.0 © 2006 Cisco Systems, Inc.

Here you will find answers to VTP & VLAN Questions If you are not sure about VTP, please read my VTP tutorial and VLAN tutorial Question 1 A network administrator is explaining VTP configuration to a new technician.

What should the network administrator tell the new technician about VTP configuration? A switch in the VTP client mode cannot update its local VLAN database. A trunk link must be configured between the switches to forward VTP updates. A switch in the VTP server mode can update a switch in the VTP transparent mode. A switch in the VTP transparent mode will forward updates that it receives to other switches. A switch in the VTP server mode only updates switches in the VTP client mode that have a higher VTP revision number. A switch in the VTP server mode will update switches in the VTP client mode regardless of the configured VTP domain membership.

A B D Question 2 ALSwitch1# show running-config «output omitted» interface Fast Ethernet0/24 no ip address «output omitted» ALSwitch1# show interfaces Fast Ethernet0/24 switchport Name: Fa0/24 Switchport: Enable Administrative Mode: static access Operation Mode: static access Administrative Trunking Encapsulation: dot1q Operation Trunking Encapsulation: native Negotiation of Trunking: Off Access Mode VLAN: 1 (default) Trunking Native Mode VLAN: 1 (default) Voice VLAN: none Administrative private-vlan host-association: none Administrative private-vlan mapping: none Operation private-vlan: none Trunking VLANs Enabled: ALL Pruning VLANs Enabled: 2-1001 Capture Mode Disabled Capture VLANs Allowed: ALL Protected: false Voice VLAN: none (Inactive) Aplliance trust: none Switch port Fast Ethernet 0/24 on ALSwitch1 will be used to create an IEEE 802.1 Q-compliant trunk to another switch.

vtp domain currently not in updating state-77vtp domain currently not in updating state-28vtp domain currently not in updating state-72

What is the reason the trunk does not form, even though the proper cabling has been attached?